Merry Christmas and a happy New Year!
…have committed to remain open for business 2024. Looking forward to a new year of continued collaboration, groundbreaking research, and shared successes. 🎄 Happy Holidays and a Happy New Year!…
…have committed to remain open for business 2024. Looking forward to a new year of continued collaboration, groundbreaking research, and shared successes. 🎄 Happy Holidays and a Happy New Year!…
…The Newton CCD camera (Newton DU970P-BVF model from Andor) is suitable for the spectral range of 200-1100 nm. The set of Hamamatsu photomultipliers (H8259, H8259-01, and H8259-02 photon counting heads)…
…buildings. The different new techniques developed for MAX IV will reduce energy consumption compared to traditional synchrotron facilities. The smaller magnets, the lower frequency used in the RF cavities and…
…XAS and SAXS with different channel depth is available at MAX IV (see below for use at Balder). New co-flow chip in use at the Balder beamline. Example of XAS…
A call for proposal will open September 4 with closing deadline September 18, 2024. For more general information about the call see https://www.maxiv.lu.se/user-access/call-for-proposals/. MicroMAX is open for standard proposals for…
…used in foods to increase the fibre content without compromising taste and texture,” says Annelie Moldin from Lantmännen. Sample holders with wheat bran to be analysed at ForMAX. Annelie Moldin,…
…most successful, while group A antigens are more complex,” explained Martin L. Olsson. “Even so, our new enzyme mix displays significantly better compatibility with group O plasmas than if only…
…properties and 2) by combining this with new experimental methods that are presently being developed at many X-ray free electron lasers (XFELs) and synchrotron radiation facilities. The aim of these…
As the planet warms, a unifying challenge will be determining ways to reduce human impact from use of natural resources. New technologies and ‘greener’ resourcing are being utilised and their…
…resistance to heat and oxidation. However, the tools are still subject to decomposition during machining. To develop cutting tools that can better withstand wear and tear, tool producers want to…